h323 config for uk and us

Unanswered Question
Jul 17th, 2007

Hello,

does anyone have a sample config for a h323 gateway for implementation in the UK, and one for the US?

Thanks...MS.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
Paolo Bevilacqua Tue, 07/17/2007 - 03:05

Hi,

you have to not look at the country, but the type of application you are doing. for example, are you connected to PBX ( specify which type and interface) to telco (again specify which interface) and more importantly, what are you trying to do.

simmo Tue, 07/17/2007 - 13:03

Hello,

this will be a CCM Gateway, with an E1 in UK, and T1 in US.

My concern is that just having a single .T peer will mean timeout delays, especially with variable length dial patterns. Here in AU, I use a template has about 8 dial peers to cover the variable length patterns.

Does that make sense?

I've attached an AU template that I use...

Paolo Bevilacqua Tue, 07/17/2007 - 13:19

Yes it make sense. However, if you use CCM, the correctness of the called number is enforced first at CCM level. I understand that there are CCM templates circulating for both UK and the US. Try posting as 'CCM dialplans for US and UK'.

So, it is safe to use destination-pattern with T on the gateway. If you want to configure it with the correct destination-patterns, you can do that, but it is not necessary.

Hope this helps, please rate post if it does!

simmo Tue, 07/17/2007 - 13:28

Hi and thanks for the reply which helps a lot.

one quick thing though - with SRST, which I forgot to mention - I'm guessing that the user might then experience delays in that circumstance...agree?

in the meantime I'll post for UK dial plans...thanks again...MS.

Paolo Bevilacqua Tue, 07/17/2007 - 13:46

You are right, in case of SRST operation, users may get a small post-dial delay when no punctual DPs configured.

But, using interdigit timeout set to a reasonable value of 4, it is not really a big issue.

Actions

This Discussion