I have a 1721 router at home and I am trying to set it up so i can vpn into it via the cisco vpn client. I got it to where I could successfully vpn in, however I could not access any networks inside. All i could do was ping one of the servers, 172.16.0.10, and all of the inside interfaces on the router. I could not access any web pages hosted on any of my servers and I could not ping the server at 192.168.1.10. Attached is my config from my router. I have tried checking allow local access in the transport options of the vpn client. My router is running crypto/ip/fw/ids/ip/... ios 12.3.22
I am not very familiar with VPNs and only recently achieved my CCNA.
I will attach my config in a seperate config i had to edit some info out
Actually, it should work.
Try to use the same pool of addresses, or the interfaces address, for all inside to outside translations.
Make sure you have added a second loopback interface, with ip nat inside configured.
Please attach the complete config again if not working, together with "sh ip nat translation" output.
I hope this helps, please rate and mark it as resolved if it does.