07-17-2007 09:40 AM - edited 03-14-2019 10:37 PM
I have a few 7960's that refuse to get an IP address. Even if I configure the 7960 with a static IP address it still does not communicate with callmanager. I've plugged in a known good 7960 into the switch port and it works fine. Everything seems to point to the phone. Any ideas?
thanks
07-17-2007 09:50 AM
Have you tried a factory reset ? What image is on the phones right now ? (Version)
07-17-2007 10:09 AM
Yes, I have tried factory resets.
image:
app load id: p00303020215
boot load id: pc03a300
07-17-2007 11:05 AM
Hi,
seems to me these are ancient firmware, can you try something more recent like 7.x or 8.x ?
07-17-2007 11:44 AM
Do you have CDP enabled on the switch? Just a thought. Didn't read initial post. It might be DOA. So far, I have had 3 out of 600 that would not boot up and we had to RMA the phone.
07-17-2007 11:47 AM
I just thought of something else, do you have the phone added in the Call Manager as the right phone type.
07-18-2007 10:48 AM
Are the devices configured on the callmanager correctly? Confirm the correct MAC address of the device on the callmanger.
07-18-2007 11:52 AM
I am having the same problem. My phones will also not allow me to change any settings, the lock is disabled but the "Select" or "Edit" buttons give the following message;
"That key is not active here". This seems very odd.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: