Cisco Works Autodiscovery

Unanswered Question
Jul 17th, 2007

Hello,

Please, how can I configure CiscoWorks LMS 2.6 for auto-discovery?. What is the module that I need to configure?

Tks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
jreekers Tue, 07/17/2007 - 15:44

Hi.

You can configure discovery of your network devices through Campus Manager.

This is when the online help will be very helpful to you. So, I think the best way for you to proceed is to go to Campus Manager -->Administration and then click "help" in the upper-right corner of the screen. That will bring up the online help and should have everything you need there to set-up discovery.

If you have any questions after this, please post them here and I'll be happy to assist.

Regards,

-Joe R.

David Stanford Tue, 07/17/2007 - 18:17

If you don't have any devices in the DCR already, you'll want to add some seed devices in Campus Manager.

The following white paper is for LMS 2.5, but has all you need for 2.6:

http://www.cisco.com/application/pdf/en/us/guest/products/ps2425/c1244/cdccont_0900aecd8026ee8d.pdf

Scroll to the section Defining a Seed device in Campus Manager. It also has info on all configurations needed on the devices.

Actions

This Discussion