cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1220
Views
10
Helpful
4
Replies

Cisco Works Autodiscovery

Hello,

Please, how can I configure CiscoWorks LMS 2.6 for auto-discovery?. What is the module that I need to configure?

Tks.

4 Replies 4

jreekers
Level 4
Level 4

Hi.

You can configure discovery of your network devices through Campus Manager.

This is when the online help will be very helpful to you. So, I think the best way for you to proceed is to go to Campus Manager -->Administration and then click "help" in the upper-right corner of the screen. That will bring up the online help and should have everything you need there to set-up discovery.

If you have any questions after this, please post them here and I'll be happy to assist.

Regards,

-Joe R.

Thank you Joe, I'll search this option and I'll apply it.

David Stanford
Cisco Employee
Cisco Employee

If you don't have any devices in the DCR already, you'll want to add some seed devices in Campus Manager.

The following white paper is for LMS 2.5, but has all you need for 2.6:

http://www.cisco.com/application/pdf/en/us/guest/products/ps2425/c1244/cdccont_0900aecd8026ee8d.pdf

Scroll to the section Defining a Seed device in Campus Manager. It also has info on all configurations needed on the devices.

Thank you davistan, I'll search this information and I'll apply it.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: