1121 Update Failure

Unanswered Question
Jul 18th, 2007
User Badges:
  • Silver, 250 points or more

the 1121 version wan 12.3-4 i upgrade to 12.3-8 the upgrade was successfull, but after restar the AP the led 1,3 flash in red, the led 2 flash in green after that the ap restar and i makes again, somebody knows how to fix this?

this is the result:




No Cisco IOS image file.

how cai fix this?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 1 (1 ratings)
smalkeric Tue, 07/24/2007 - 13:15
User Badges:
  • Silver, 250 points or more

Disconnect power (the power jack for external power or the Ethernet cable for in-line power) from the access point. Press and hold the MODE button while you reconnect power to the access point.Hold the MODE button until the status LED turns red (approximately 20 to 30 seconds), and release the MODE button. Wait until the access point reboots as indicated by all LEDs

turning green followed by the Status LED blinking green. Then reload the imgae using TFTP.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode