07-18-2007 08:13 PM - edited 03-14-2019 10:39 PM
Hi,
I'm fairly new to the callmanager and was after some advice/direction on trying to set up the following lab environment.
I have a 2821 gateway connected to the PSTN via PRI ISDN. Callmanager 4.2 setup and able to make outgoing calls.
Now, I have added another callmanager (seperate cluster) to the same internal network and was wanting to connect it to a second 2821 router. I was wanting connect this second gateway to the first gateway via a H.323 trunk. Some advice on how to begin setting this up?
First gateway: 2821 router
internal IP: 192.168.1.1
external PSTN: PRI ISDN
Second gateway: 2821 router
internal IP: 192.168.1.2
Do I setup a H.323 trunk between 192.168.1.1 and 192.168.1.2 and can I then route calls the the first callmanager that then will route external calls out the first gateway's PSTN link.
Thanks in advance...
07-18-2007 10:18 PM
PSTN -- 2821-A --- 2821B --- CCM2
This 2821 should allow connections from h323 to h323.
You only need to create dial-peers in both routers...
in 2821B doing the dialplan that match dial-peer pots in 2821A.
in 2821A dial-peer VOIP for incoming calls from PSTN to CCM2.
07-18-2007 11:32 PM
Thanks for the reply.
How do I create an endpoint on the 2821B? It is only connected via ethernet port (not to PSTN).
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: