6608 PRI ISDN Q.931 Outpulse

Unanswered Question
Jul 19th, 2007

The 66xxTracy utility doesn't appear to offer Q.931 isdn debugs similar to what we get from IOS q931 isdn degubs. I want to see the digits being handed off, and the IE information being passed to telco. I've enabled all of what seemed to be the relevant masks in the 66xxTracy tool, but I'm not seeing what I was looking for. Here are the masks I enabled:

10:34:39.120 (LINE) TraceMask value = 00000003

Where Bit0 = Call Control Statess

Bit1 = Q931

Bit2 = Q931 Msg's

Bit3 = Line Restarts

Bit4 = E&M Trunk States/Events

Bit5 = Ground Start Trunk States/Events

Bit6 = Loop Start Trunk States/Events

Bit7 = Robbed Bit Signalling Changes

(GMSG) Set Mask -> Mask<0xFF>

(CFG) Set Mask -> Mask<0x0>

(XA) Set Mask -> Mask<0x7>

10:34:39.120 SPAN: --> TraceMask value = 00000040

TraceMask bit 0x01 --> Show Frameslips

TraceMask bit 0x02 --> Show Alarm Changes

TraceMask bit 0x04 --> Show HDLC Rx Errors

TraceMask bit 0x08 --> Show HDLC Tx/Rx Msgs

TraceMask bit 0x10 --> Show FDL Errors

TraceMask bit 0x20 --> Show ANSI PRM Tx/Rx

TraceMask bit 0x40 --> Show FDL BOCs

TraceMask bit 0x80 --> Show FDL TABS Req/Resp

TraceMask bit 0x100 --> Show Raw 1-sec Stats

TraceMask bit 0x200 --> Show Rcv Signalling Changes

10:34:39.120 (Q921) --> TraceMask value = 000000ff

Where Bit0 = BackHaul Status Messages -- DL-Est Req/Cfm, DL-Rel Req/Cfm, ...

Bit1 = BackHaul Operational Messages -- Data Ind/Req

Bit2 = D-Channel Messages -- SABME, UA, DISC, RR, ...

Bit3 = Timer Events

Bit4 = Error Events

Bit5 = State Machine Events

Bit6 = Show Variables in I-Frame Received

Bit7 = Decoded PRI Q.931 Messages

Are the ccm traces the only place I will see ISDN information of this nature, or is there a way to get this info from 66xxTracy? (4.1(3)SR5B)

Thank you.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
s-doyle Wed, 07/25/2007 - 07:08

ccm trace is the only place you can see ISDN information of this nature


This Discussion