access-list binding help required

Unanswered Question
Jul 20th, 2007
User Badges:

Hello,


This is regarding SNMP config on 2980G Catos switch for ver 8.4.9


We have issued the following commands on the switch:


1)For SNMP Access list : set snmp access-list access_number IP_address [ipmask maskaddr]



I would like to know how binding of access-list are done and where when we defining for SNMP configuration



Regards,

Arindam



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
purohit_810 Sun, 07/22/2007 - 09:18
User Badges:
  • Silver, 250 points or more


You can do by using following two commands


router(config)#snmp-server community MyCommunity972 RW 10

router(config)#access-list 10 permit 192.168.1.23


{Note: RW 10 that much be match with access-list No}


Regards,

Dharmesh Purohit

royalblues Sun, 07/22/2007 - 11:40
User Badges:
  • Green, 3000 points or more

There is no binding required. The access-list number mentioned is referenced for all the SNMP inout packets.


Its something similar to using access-list when debugging or for PBR.


HTH

Narayan

Actions

This Discussion