07-20-2007 12:45 PM - edited 03-05-2019 05:25 PM
Hello,
This is regarding SNMP config on 2980G Catos switch for ver 8.4.9
We have issued the following commands on the switch:
1)For SNMP Access list : set snmp access-list access_number IP_address [ipmask maskaddr]
I would like to know how binding of access-list are done and where when we defining for SNMP configuration
Regards,
Arindam
07-22-2007 09:18 AM
You can do by using following two commands
router(config)#snmp-server community MyCommunity972 RW 10
router(config)#access-list 10 permit 192.168.1.23
{Note: RW 10 that much be match with access-list No}
Regards,
Dharmesh Purohit
07-22-2007 11:40 AM
There is no binding required. The access-list number mentioned is referenced for all the SNMP inout packets.
Its something similar to using access-list when debugging or for PBR.
HTH
Narayan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: