07-20-2007 04:36 PM - edited 03-05-2019 05:25 PM
Hello,
This is regarding SNMP config on 2980G Catos switch for ver 8.4.9
We have issued the following commands on the switch:
1)For SNMP Access list : set snmp access-list access_number IP_address [ipmask maskaddr]
I would like to know where the binding of access-list would be done when we defining for SNMP configuration
Regards,
Arindam
07-20-2007 10:13 PM
Arindham,
There is no need to bind the access-list to any interface.
When you configure the above command, then only the stations with IP address in the access-list are allowed to poll.
HTH
Narayan
07-21-2007 08:25 AM
Thanks Narayan for yours input
07-21-2007 02:03 AM
This command automatically binds selected ACL to SNMP server on the switch. Requests can come from any interface.
ACL works for incoming requests only.
07-21-2007 08:25 AM
Thanks for yours input.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: