07-22-2007 03:06 AM - edited 03-03-2019 05:58 PM
Hi
which model of CISCO catalyst switches
support T1/E1 port?
07-22-2007 04:38 AM
Hi,
Only Cat 6500 supports T1/E1 interface.
Please rate if the info was usefull.
Thanks
Deepinder Singh Babbar
07-22-2007 05:26 AM
is there any convertor or other thing
less expensive to support E1 for cat switches?
thank you.
07-22-2007 05:44 AM
There nothing that can be considered low cost for supporting E1/T1 on 6500. This is the only module supporting T1/E1. Though for voice E1/T1 there are other modules which are also very expensive like "Communication Media Module WS-SVC-CMM ", "WS-X6608-E1" & "WS-X6608-T1".
07-22-2007 06:31 AM
Hello,
You should use a router for E1 circuits, not a switch. Current production, the smaller would be a 1841, older models, a 1720. In both cases, you need a WVIC-MFT-1E1
These are very cheap when bought used.
Hope this helps, please rate post if it does!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide