PIX 7.2 logical interfaces

Unanswered Question
Jul 22nd, 2007

I am trying to configure logical interfaces on a PIX 515 with 7.2(2)

The documentation for the PIX 6.3 shows the steps:

interface ethernet0 aut0

interface ethernet0 vlan2 physical

interface ethernet0 vlan3 logical

nameif ethernet0 outside security0

nameif vlan3 dmz security50

ipaddress outside 192.168.101.1 255.255.255.0

ipaddress dmz 192.168.103.1 255.255.255.0

I cannot seem to get anywhere with these commands, I cannot get past the Ethernet0.

Have the commands changed that much for the 7.2 software ?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
JBDanford2002 Sun, 07/22/2007 - 14:30

Yes they have changed alot. Now you configure subinterface commands.

ciscopix(config-if)# interface vlan 100

ciscopix(config-if)# nameif DMZ1

ciscopix(config-if)# security-level 50

ciscopix(config-if)# ip address 192.168.1.1 255.255.255.0

ciscopix(config-if)# no shutdown

ciscopix(config-if)# interface vlan 101

ciscopix(config-if)# nameif DMZ2

ciscopix(config-if)# security-level 75

ciscopix(config-if)# ip address 192.168.2.1 255.255.255.0

ciscopix(config-if)# no shutdown

ciscopix(config-if)# interface ethernet 0/1

ciscopix(config-if)# switchport mode trunk

ciscopix(config-if)# switchport trunk allowed vlan 100-101

ciscopix(config-if)# no shutdown

Actions

This Discussion