WIC-2A/S

weiliang82 · ‎07-22-2007

Hi all,

Can i configure the WIC-2A/S serial interface to 24.4kbps bandwidth? Will it be rounded up to 19.2kbps if i configure the bandwidth to 24.4kbps?

Pls advice.

Thank you.

paolo bevilacqua · ‎07-22-2007

Synch or asynch mode ?

I don't think you can have 24.4 Kbps in asynch mode. While it should be no problem in synch mode.

Hope this helps, please rate post if it does!

weiliang82 · ‎07-23-2007

but base on datasheet, WIC-2A/S can support up to 128kbps for async and sync mode. That why i'm wondering whether can i specified the link to be 24.4kbps, or the serial bandwidth have prefix value, meaning that can only configure 2.4kbps, 4.8kbps, 9.6kbps, 19.2kbps, 38.4kbps....

Kindly advise.

paolo bevilacqua · ‎07-23-2007

Usually the asynch speeds are locked for common speeds, so I'm not sure that 24.4 is among these. You would need to try on an actual module.

weiliang82 · ‎07-23-2007

Thanks for your advise. :)