PEAP in Wireless Enterprise Network

Unanswered Question
Jul 23rd, 2007

I am trying to user PEAP on my AP's in the Enterprise. It works fine when used as WPA2. But when i use dot1x it gives me error 'auidentified server identity'. I am using ACS 3.3 & using self signed cert. on the ACS. The same cert. i have installed in one Wireless Client. but it gives me error all the time. The error in ACS failed attempt is 'EAP-TLS or PEAP authentication failed during SSL handshake'

Pl. help.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
dsweeny Fri, 07/27/2007 - 12:33

Its possible that certificate on client is not properly able to authenticate ACS server certificate.

Please check following :

Install the Root CA Certificate for the Client :

Complete these steps.

[1] From the client PC, browse to the CA -http://IP_of_CA_server/certsrv/.

[2] Select Retrieve a CA certificate and click Next.

[3] Select Base64 Encoding and Download CA certificate.

[4] Click Open and select Install Certificate.

[5] Click Next.

[6] Select Place all certificates in the following store and then click Browse.

[7] Check the Show physical stores box.

[8] Expand Trusted root certification authorities, select local computer, and click OK.

[9] Click Next, click Finish, and click OK for "The import was successful" box.

Set up the Client for PEAP:

rochopra Fri, 07/27/2007 - 19:38

Does it work fine if you uncheck "verify server certificate" in PEAP settings.

~Rohit

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode