2620 and Cisco SDM

Unanswered Question
Jul 24th, 2007

We are currently running c2600-is-mz.120-7.T2.bin on a 2620. We would like to use Cisco SDM to monitor the router.

We only have the following memory :-

libabb#sh vers

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-IS-M), Version 12.0(7)T2, RELEASE SOFTWARE (fc1)

TAC Support: http://www.cisco.com/tac

Copyright (c) 1986-2002 by cisco Systems, Inc.

Compiled Sun 10-Feb-02 00:28 by ccai

Image text-base: 0x80008088, data-base: 0x80C52A94

ROM: System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1)

libabb uptime is 21 weeks, 5 days, 9 hours, 53 minutes

System returned to ROM by power-on

System image file is "flash:c2600-is-mz.120-7.T2.bin"

cisco 2620 (MPC860) processor (revision 0x600) with 26624K/6144K bytes of memory


Processor board ID JAD05500NBS (231475022)

M860 processor: part number 0, mask 49

Bridging software.

X.25 software, Version 3.0.0.

1 FastEthernet/IEEE 802.3 interface(s)

1 Serial network interface(s)

32K bytes of non-volatile configuration memory.

8192K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102


Directory of flash:/

1 -rw- 7331652 <no date> c2600-is-mz.120-7.T2.bin

8388608 bytes total (1056892 bytes free)

Can you please advise on a IOS version we should use, and if we need to upgrade the flash/ DRAM etc to run Cisco SDM.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)


This Discussion