Aggressive Mode Configuration

Unanswered Question
Jul 24th, 2007
User Badges:

In a VPN configuration I have a cisco 1700 router and on the other side I have a Firewall. I need to configure the Aggressive Mode that the firewall has already set on the router, so both devices can manage dinamic IP adresses from the ISP.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Anonymous (not verified) Mon, 07/30/2007 - 09:23
User Badges:

To configure the Cisco VPN 500x to support LAN-to-LAN connections, it is necessary to define the tunnel configuration, as well as the IP communication parameters that are used in the tunnel. This is accomplished in two sections, the [Tunnel Partner VPN x] section, and the [IP VPN x] section. For any given site-to-site configuration, the (x) defined in these two sections must match, so that the tunnel configurations are properly associated with the protocol configuration.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2301/products_tech_note09186a00801e4db9.shtml

Actions

This Discussion