07-24-2007 11:54 PM - edited 03-05-2019 05:28 PM
hi,
i want view how an access-list don't work properly but i want solve myself this problem.
I want use "debug IP packet detailed" for debug packet, but when i digit
Router#debug ip packet
i recive
IP packet debugging is on
how do i make to show debug?
thank in advantage.
regards
daniele
Solved! Go to Solution.
07-25-2007 08:20 AM
Hi Friend,
Not that I know off!! AFAIK only standard, extended access and expanded access list can be specified.
But you can use "term mon" to view any debugs on telnet session.
HTH
Ankur
*Pls rate all helpfull post
07-25-2007 12:47 AM
Hi Daniele,
If this is a telnet session then you need to enable "term mon" on enable prompt
Router#terminal monitor
Also I will recommend not to use debug ip packet as it may affect router CPU , I will suggest if you just want to troubleshoot an access list using debug command use "debug ip packet detail
HTH
Ankur
*Pls rate all helpfull post
07-25-2007 08:13 AM
Hi, thank you for your reply.
I've a named access-list, can i debug it?
i see that i can specify only access-list number
07-25-2007 08:20 AM
Hi Friend,
Not that I know off!! AFAIK only standard, extended access and expanded access list can be specified.
But you can use "term mon" to view any debugs on telnet session.
HTH
Ankur
*Pls rate all helpfull post
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: