E3 Multichannel config G703

Uzziel Sevilla Castillo · ‎07-25-2007

HI, I NEED CONFIG A E3 MULTICHANNEL TO USE G703 FULL IN INTERNET, I NEED SAMPLE OF CONFIGURATION. THANKS

purohit_810 · ‎07-25-2007

Hi,

conftroller e3

framing no-crc4

No shut

After that one serial interface popup:

int serial {No}

Encap ppp

Ip address {Ip add with subnet mask}

ppp multilink

Regards,

Dharmesh Purohit

paolo bevilacqua · ‎07-25-2007

No sure why the reply above assumes so many things incorrectly:

- framing no-crc4, that is not an option for E3.

- that PPP is used with multlink ???

To go back to original question, is that a PA-MC-E3 interface? or module it is exactly ?

Uzziel Sevilla Castillo · ‎07-25-2007

is a port adapter, i need configure this port to receive all the bandwidth complete g703 of my ISP in this card .

Thanks

Uzziel Sevilla Castillo · ‎07-26-2007

in this card E3 my ISP deliver me bandwidth full to internet G703 over 1 channel only i need the sample to configure this interface.

thanks.

paolo bevilacqua · ‎07-26-2007

Hi,

Do you have PA-MC-E3 or PA-E3? If the latter, non-channelized E3, there is no configuration beside assigning IP address to interface.

Uzziel Sevilla Castillo · ‎07-26-2007

hi.

is a PA-MC-E3

THANKS.

paolo bevilacqua · ‎07-26-2007

Hello,

PA-MC-E3 cannot be used for unchannelized E3 (clear-channel @ 34 Mbps). Please refer to the following document to understand the application of PA-MC-E3:

http://cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800a72c0.shtml

As a recognition to those providing answers, please rate useful posts using the scrollbox below!