07-25-2007 09:56 AM - edited 03-03-2019 06:01 PM
HI, I NEED CONFIG A E3 MULTICHANNEL TO USE G703 FULL IN INTERNET, I NEED SAMPLE OF CONFIGURATION. THANKS
07-25-2007 10:15 AM
Hi,
conftroller e3
framing no-crc4
No shut
After that one serial interface popup:
int serial {No}
Encap ppp
Ip address {Ip add with subnet mask}
ppp multilink
Regards,
Dharmesh Purohit
07-25-2007 11:08 AM
No sure why the reply above assumes so many things incorrectly:
- framing no-crc4, that is not an option for E3.
- that PPP is used with multlink ???
To go back to original question, is that a PA-MC-E3 interface? or module it is exactly ?
07-25-2007 12:18 PM
is a port adapter, i need configure this port to receive all the bandwidth complete g703 of my ISP in this card .
Thanks
07-26-2007 12:29 PM
in this card E3 my ISP deliver me bandwidth full to internet G703 over 1 channel only i need the sample to configure this interface.
thanks.
07-26-2007 12:34 PM
Hi,
Do you have PA-MC-E3 or PA-E3? If the latter, non-channelized E3, there is no configuration beside assigning IP address to interface.
07-26-2007 12:49 PM
hi.
is a PA-MC-E3
THANKS.
07-26-2007 01:56 PM
Hello,
PA-MC-E3 cannot be used for unchannelized E3 (clear-channel @ 34 Mbps). Please refer to the following document to understand the application of PA-MC-E3:
http://cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800a72c0.shtml
As a recognition to those providing answers, please rate useful posts using the scrollbox below!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide