1841 VWIC 1MFT-T1 configuration

Unanswered Question
Jul 25th, 2007
User Badges:

It's been a while. I need to configure an interface for the T1 controller. Any help would be appreciated. I thought it was a virtual serial interface, but can't for the life of me get it going here. I am open to suggestions.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
pstebner1 Wed, 07/25/2007 - 12:23
User Badges:

Hi William-

Assuming you have the framing and linecode, first you configure the controller:


Router(config)#controller t1 0/1

Router(config-controller)#framing esf

Router(config-controller)#linecode b8zs

Router(config-controller)#channel-group 1 timeslots 1-24


Then the serial interface:


Router(config-controller)#int s0/0:1

Router(config-if)#ip address xx.xx.xx.xx 255.255.yy.yy

(if it's a point-to-point):

Router(config-if)#encap ppp


Tha't about it. Let me know if you have any specific requirements that I didn't cover.


HTH,

Paul





william.culver@... Wed, 07/25/2007 - 12:38
User Badges:

It's all coming back. I think that should do it. Will know for sure when the line gets turned up tomorrow. Appreciate the help.


jay77jay77 Wed, 07/25/2007 - 18:05
User Badges:

hi its not necessarily be encap PPP on point to point interface. Even if u dont do the

encap PPP command the link shud come up.


If you do encap PPP, you need to do it on the remote end of the link too...


Cheers!

Actions

This Discussion