EPHRAIM MANI Wed, 07/25/2007 - 16:46

What is that can you brief us more on this or what exactly you require here.

Thanks EM-

sungjin78 Wed, 07/25/2007 - 16:57

Ok, Sorry

We use 3550-24SMI switch.

Today Ios Upgrade

c3550-ipservicesk9-mz.122-25.SEE3.bin

Upgrade before

c3550-i9q3l2-mz.121-13.EA1c.bin

Ios Upgrade After

Duplex mismacth happen

End-to-End

1case

A:100/FULL

B:A/A half operation

ios upgrade before no duplex mismatch

ios upgrade after duplex mismatch happen

We action

A:A/A

No happen duplex mismatch Configure change after

2case

A:100/FULL

B:AUTO/AUTO HALF opreation

B:100/FULL change Configure after no happen

Pavel Bykov Wed, 07/25/2007 - 22:43

Set both sides to A/A, or set your both sides to 100/F (or 1000/F if it's a Gigabit port)

Duplex is negotiated at the start. When you are using AUTO (A/A), there is negotiation, but when you have manual settings (100/F), no negotiation is taking place from that side!

I.E. Only side with A/A will negotiate duplex.

Negotiation implementation is not very consistent throughout vendors. So i would recommend switching to 100/F or 1000/F whenever you would experience problems.

I think the problem you got was because of switch reload, not because of switch upgrade. It was just luck that port got correct settings in the case before.

Actions

This Discussion