E1 back to back on same H323 Gateway

Unanswered Question
Jul 26th, 2007
User Badges:

I have a test plateforme with to PSTN provider and with only one 2821 voice gateway.

I'd like to simulate the PSTN by linking the 2 E1 controller on the VWIC-2MFT-T1/E1 of my gateway using to E1 cross-cable.

At the beginnig I did in MGCP but it didn't work probably due to CCM loop avoidance mechanism, then I did in H323 but it still not working.

Do you have any idea if it is possible or not?

I attached to conf if you want to have a look.


PS:all test numbers start with 69XXX ,I created a route pattern "*.69XXX" to use the H323 gawteway to force call to go through the GW



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
luc.charpentier Thu, 07/26/2007 - 04:59
User Badges:

Any ideas ?

Could b every usefull with only 1 voice gateway and no PSTN provider.


Thanks


Luc

phershaw Fri, 07/27/2007 - 02:08
User Badges:

Luc,


For starters, try making the following changes:


dial-peer voice 100

incoming called-number .

!

dial-peer voice 1

incoming called-number .

destination-pattern .T

!


debug isdn q931 should help you see what's happening.


Phil

Actions

This Discussion