Hi I used to have consult transer without the need to daul line the phones . Not sure what has happend in the last hour but I now cant do it.
Here is my Tel Service
load 7960-7940 P00307020200
load 7914 S00105000200
ip source-address 10.1.1.254 port 2000
auto assign 1 to 50
network-locale 1 GB
network-locale 2 GB
network-locale 3 GB
network-locale 4 GB
max-conferences 8 gain -6
You are going to have to use either two extensions or Dual-Line if you want Consult Transfer. Have you tried this for the Dual-Line phones?
To allow call-waiting beeps to be accepted by or generated from an ephone-dn, use the call-waiting beep command in ephone-dn or ephone-dn-template configuration mode. To disable the acceptance and generation of call-waiting beeps by an ephone-dn, use the no form of this command.
call-waiting beep [accept | generate]
no call-waiting beep [accept | generate]
The call-waiting beep command must be used with the ephone-dn command. The call-waiting beep command is used like a toggle and can be switched on and off for each ephone-dn.
A beep can be heard only if both sending and receiving ephone-dns are configured to accept call-waiting beeps.
To display how call-waiting beeps are configured, use the show running-config command in the privileged EXEC configuration mode. If the no call-waiting beep generate and no call-waiting beep accept commands are configured, the show running-config output will display the no call-waiting beep command.
If you configure a button to have a silent ring using the s option of the button command, you will not hear a call-waiting beep regardless of whether the ephone-dn associated with the button is configured to generate a call-waiting beep.
If you use an ephone-dn template to apply a command to an ephone-dn and you also use the same command in ephone-dn configuration mode for the same ephone-dn, the value that you set in ephone-dn configuration mode has priority.
From this good CME doc;
Call-Waiting Beep: Example
In the following example, ephone-dn 10 neither accepts nor generates a beep, ephone-dn 11 does not accept a beep, and ephone-dn 12 does not generate a beep.
no call-waiting beep
no call-waiting beep accept
no call-waiting beep generate
Hope this helps!
Please remember to rate helpful posts.....