ip routing

Unanswered Question
Jul 26th, 2007


We recently established a metro link connecting a remote office. Site A is a public network, Site B is a private network. The routers appear to be talking to each other. Site A also has a Cisco 1605R connecting it to the Internet. I ran the following command on it the establish a static route to the router to Site B:

config terminal ip route

However, commands sent to the private network still are being routed to the Cisco.

Am I missing another command somewhere?

Here is the result from a 'show ip route'

united_imaging>show ip route

Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP

D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area

N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP

i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area

* - candidate default, U - per-user static route, o - ODR

P - periodic downloaded static route

Gateway of last resort is to network is subnetted, 1 subnets

C is directly connected, Ethernet1

S [1/0] via

S* is directly connected, Serial0

Thank you in advance for you help,


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Amit Singh Thu, 07/26/2007 - 09:48


Could you please send the config for both the routers Router A and Router B. Do a traceroute to 192.168.1.x any host and check where are you going through it.

Also, Please paste a brief network topology.

-amit singh

ui1cisco2 Fri, 07/27/2007 - 08:39


Sorry, what exactly are you looking for as far as the topology? I can create a simple diagram if your wish.

Thank you again,


ui1cisco2 Fri, 07/27/2007 - 08:46


I attempted to post my 'show config' results to you, but somehow they did not show up on the forum. Can you please confirm whether or not you got them?




This Discussion