NAC - Issues with Switch, CAM and SNMP

Unanswered Question
Jul 27th, 2007

I am installing a CAS and a CAM for the first time. My first step is to change vlans in 2950 switch, using the CAM.

My topology is out-of-band real ip gateway.

I have the switch in CAM, I configured port profile (auth vlan (10), default access vlan (11) and access vlan (11)). I also assign this new port profile in one port of the switch.

By default I put the access vlan (11) in all switch ports.

My problem is when I connect a PC to the port controled by the CAM. CAM should change the port from vlan 11 to vlan 10 and I cannot acheive that.

This way I can not test PBR, and the CAS.

I also tried to put the controled port on auth vlan (10) and the auth page is not displayed in the browser.

Can you give me a help?

Best regards,

Jo?o Carvalho

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion