cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
993
Views
0
Helpful
4
Replies

PIM DENSE MODE in Switch 3560

vipinyadav84
Level 1
Level 1

Sir,

I want enable PIM DM in my Cisco switch 3560.

The error i get while configuring is "input not detected".Please Reply..

4 Replies 4

Jon Marshall
Hall of Fame
Hall of Fame

Hi

Could you post output of "sh ver" and also post the configuration commands you are using to configure pim.

Jon

Cisco IOS Software, C3560 Software (C3560-IPBASE-M), Version 12.2(25)SEE2, RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2006 by Cisco Systems, Inc.

Compiled Fri 28-Jul-06 07:19 by yenanh

Image text-base: 0x00003000, data-base: 0x00EB0F14

ROM: Bootstrap program is C3560 boot loader

BOOTLDR: C3560 Boot Loader (C3560-HBOOT-M) Version 12.2(25r)SEC, RELEASE SOFTWARE (fc4)

GoldstoneTechnologies uptime is 2 weeks, 1 day, 3 hours, 8 minutes

System returned to ROM by power-on

System image file is "flash:c3560-ipbase-mz.122-25.SEE2/c3560-ipbase-mz.122-25.SEE2.bin"

cisco WS-C3560-24TS (PowerPC405) processor (revision D0) with 118784K/12280K bytes of memory.

Processor board ID CAT1108ZJ1N

Last reset from power-on

1 Virtual Ethernet interface

24 FastEthernet interfaces

2 Gigabit Ethernet interfaces

The password-recovery mechanism is enabled.

512K bytes of flash-simulated non-volatile configuration memory.

Base ethernet MAC Address : 00:1A:E3:EF:41:00

Motherboard assembly number : 73-9897-06

Power supply part number : 341-0097-02

Motherboard serial number : CAT110850YV

Power supply serial number : AZS110410N6

Model revision number : D0

Motherboard revision number : A0

Model number : WS-C3560-24TS-S

System serial number : CAT1108ZJ1N

Top Assembly Part Number : 800-26160-02

Top Assembly Revision Number : C0

Version ID : V02

CLEI Code Number : COMMG00ARB

Hardware Board Revision Number : 0x01

Switch Ports Model SW Version SW Image

------ ----- ----- ---------- ----------

* 1 26 WS-C3560-24TS 12.2(25)SEE2 C3560-IPBASE-M

Configuration register is 0xF

interface vlan 1

ip address 192.168.3.10 255.255.255.0

ip pim dense-mode

Hi

You have the IP Base image which does not support multicast routing.

You need the IP Services image to do this.

HTH

Jon

Hi Vipim,

As Jon stated you need ip services image.

So download image "c3560-ipservices-mz.122-25.SEE2.bin "

Also you can use Feature Navigator for finding features in particular images and platforms

http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

Regards,

Ankur

*Pls rate all helpfull post

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card