07-28-2007 03:26 AM - edited 03-03-2019 06:04 PM
EXISTING;
-2 CORE SWITCH
-4GBIC - PORT CHANEL 1 ON EACH CORE
-PORT CHANEL 1 CONFIGURED FOR HSRP
QUESTION;
-for now, correct me if iam wrong, hsrp is tracking the whole port channel 1 and monitoring it as single interface.
-is it possible to track if say 2 of the 4gbic interfaces fails then activate the standby hsrp?
what will happend if 1 of the 4 links actualy fails?
thanks.
07-28-2007 07:58 AM
Can we see the config ?
You can setup HSRP to track links on that port and decrement its priority accordingly.
07-28-2007 10:11 PM
you mean tracking each port (4 gig ports) that are configured in port chanel 1?
is it like below?
standby 10 track int g1/1 5
standby 10 track int g1/2 5
standby 10 track int g1/3 5
standby 10 track int g1/4 5
07-28-2007 10:26 PM
Hi,
I don't see any direct command under portchannel HSRP configuration which will track individual interfaces / ports under that portchannel.
But you can do so with normal tracking with explicit priority command like, you can give
standby track
ip address 10.1.1.1 255.255.255.0
standby ip 10.1.1.3
standby priority 110
standby track serial0 10
standby track serial1 10
Hope it clears your doubts,
Rate if it deos,
Rgs
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: