07-30-2007 02:15 AM
Hi,
I am having problem in calling BRI from PRI. I am getting below message while debugging. Also note that calling from BRI to PRI is successful.
Mar 2 23:38:22: ISDN BR0/0 Q931: RX <- SETUP pd = 8 callref = 0x04
Sending Complete
Bearer Capability i = 0x8890
Standard = CCITT
Transer Capability = Unrestricted Digital
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0x89
Progress Ind i = 0x8281 - Call not end-to-end ISDN, may have in-band info
Calling Party Number i = 0x2183, '1726601501'
Plan:ISDN, Type:National
*Mar 2 23:38:22: ISDN BR0/0:1: Incoming call rejected, unbindable
*Mar 2 23:38:22: ISDN BR0/0 **ERROR**: host_incoming_call: DIALER ERROR 0x1: b channel 0, call id 0x15E
*Mar 2 23:38:22: ISDN BR0/0 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x84
Cause i = 0x8095 - Call rejected
Pls help me.
Anis
9229109694
07-30-2007 02:30 AM
Please send BRI router config and what router / card it is.
07-30-2007 02:36 AM
07-30-2007 03:53 AM
Hi ,
Pease configure username and password on both routers ...in privileged mode.
cheers :)
satish
07-30-2007 03:59 AM
Dear Satish,
Can u pls give me an example for this config.
As Enable Secret is already configured on both the Routers.
Anis
07-30-2007 05:17 AM
Yes you have to configure "ppp chap username" under dialer interface.
07-31-2007 01:08 PM
PPP Multilink is not been enabled...
If it is enable than use rotary group command.
" EITHER " command.
Regards,
Dharmesh Purohit
07-31-2007 08:02 PM
Dear Dharmesh,
Can u pls explain where to enable PPP Multilink.
Dear p.bevilacqua ,
I did what u told (configure "ppp chap username" under dialer interface), but the problem is same.
Anis
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: