07-30-2007 04:16 AM - edited 03-03-2019 06:05 PM
I'm using GTS (Generic Traffic Shaping) on interface (I would like to limite trafic to 2MBps), and I would like to configure WFQ, which is the default algorithm working with GTS. But I can't succeed to configure the size of the queue. Do you know how can I do?
07-30-2007 05:32 AM
Hi,
As I know the WFQ cannot be configured just can be enabled or disabled by fair-queue (or something like that) command on per interface basis. This flow based qos technique classifies the traffic and you will have a queue for each flow and the scheduler will service each queue by some algorithm. You don't have the option to influence it.
Hope it helps, rate if does
Krisztian
07-30-2007 06:41 AM
My experience is GTS uses WFQ within the shaper itself. Don't believe you have any control over its WFQ settings. Something you might need to check with TAC.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: