GTS and WFQ

Djule2804 · ‎07-30-2007

I'm using GTS (Generic Traffic Shaping) on interface (I would like to limite trafic to 2MBps), and I would like to configure WFQ, which is the default algorithm working with GTS. But I can't succeed to configure the size of the queue. Do you know how can I do?

kerek · ‎07-30-2007

Hi,

As I know the WFQ cannot be configured just can be enabled or disabled by fair-queue (or something like that) command on per interface basis. This flow based qos technique classifies the traffic and you will have a queue for each flow and the scheduler will service each queue by some algorithm. You don't have the option to influence it.

Hope it helps, rate if does

Krisztian

jwdoherty · ‎07-30-2007

My experience is GTS uses WFQ within the shaper itself. Don't believe you have any control over its WFQ settings. Something you might need to check with TAC.