New to Cisco - Pix 506E forwarding ports and VPN

m-berryman · ‎07-30-2007

Hi,

I have a couple of PIX 506E firewalls, and am trying to figure out how to configure them for my network. I'm tryin to use PDM 3.0, because my command line abilities aren't good yet, but I'm learning. I'm trying to figure out two specific things. 1) How to port forward certain traffic (smtp, terminal services, etc)to an internal server with a static IP. Do you do this through access rules in PDM?

2) I want to set up the 2nd 506E in our remote office and have VPN between them. Is there a guide somewhere to set this type of thing up? I'm searching Cisco's site, but haven't found anything yet.

Thanks, Mike

srue · ‎07-30-2007

There are configuration examples for a lot of stuff on Cisco's website...

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/prod_configuration_examples_list.html

just a warning, these are probably mostly CLI examples.

Here's a port redirection example:

http://www.cisco.com/en/US/docs/security/pix/pix63/configuration/guide/mngacl.html#wp1090663

here are site to site vpn examples:

http://www.cisco.com/en/US/docs/security/pix/pix63/configuration/guide/sit2site.html