07-30-2007 11:52 AM - edited 03-11-2019 03:51 AM
Been reading through the forum as well as checking the download section and the documentation...can't find an Upgrading PIX to 8.0(2). Is there an official upgrade path?
I'm currently on 7.0(2) and I've seen in the forum mention of having to go to 7.1 first, then to 8.0 - is this necessary?
Is there an Admin Guide for 8.0(2) yet for referral?
Also, anyone who's running 8.0(2) - Any comments as far as likes and dislikes?
07-30-2007 01:03 PM
You need to uprade from 7.2
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v80/r_note/pixrn80.htm#wp43534
Check out this user guide,
http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_80/conf_gd/index.htm
Regards,
~JG
07-31-2007 12:36 PM
Follow Below steps:
Step 1 Load the new Version 8.0(2) image from the following website:
http://www.cisco.com/pcgi-bin/tablebuild.pl/asa
Step 2 Reload the device to upgrade to the Version 8.0(2) image.
Step 3 Copy the new ASDM Version 6.0 image from the following website:
http://www.cisco.com/pcgi-bin/tablebuild.pl/asa
Step 4 Enter the following command to tell the security appliance where to find the ASDM image:
hostname(config)# asdm image flash:/asdmfile
Or Link:
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v80/r_note/pixrn80.htm
and
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v80/index.htm
Regards,
Dharmesh Purohit
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide