G.703 to V.35 configs

Unanswered Question
Aug 1st, 2007
User Badges:

Hi,


I have a LL (2mbps) one end of which is having V.35 o/p and the far(remote) end it is G.703 o/p.These are the o/p from the modem. Would they work with each other....

sample config would be more helpful...


Thanks,

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (2 ratings)
Loading.
paolo bevilacqua Wed, 08/01/2007 - 02:14
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Yes, they will work. On the G.703 side, uncer controller configure channel-group with as many timeslots you are given. Beside this there is no special configuration, just a normal serial line like any other.

sagar.shetty Wed, 08/01/2007 - 02:19
User Badges:

Thanks


I am having smart serial card at V.35 side..


Which of the following would be better for the G.703 side...

VWIC-1MFT-E1

VWIC-1MFT-G703


I would only have just a plain E1 data link

paolo bevilacqua Wed, 08/01/2007 - 03:46
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

VWIC-1MFT-E1 should be fine. The other type is only when you have unframed link running at 2.048 mbps. And even if it is that what you have. MFT-E1 will work anyway, but at 1.948 mbps.

paolo bevilacqua Wed, 08/01/2007 - 04:18
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Small correction: 31 timeslots is 1.984, not 1.948 Mbps.

Thanks for the rating and good luck!

Actions

This Discussion