I have a LL (2mbps) one end of which is having V.35 o/p and the far(remote) end it is G.703 o/p.These are the o/p from the modem. Would they work with each other....
Yes, they will work. On the G.703 side, uncer controller configure channel-group with as many timeslots you are given. Beside this there is no special configuration, just a normal serial line like any other.
VWIC-1MFT-E1 should be fine. The other type is only when you have unframed link running at 2.048 mbps. And even if it is that what you have. MFT-E1 will work anyway, but at 1.948 mbps.
Small correction: 31 timeslots is 1.984, not 1.948 Mbps.
Thanks for the rating and good luck!
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
