PIX Boot Problem

Unanswered Question
Aug 1st, 2007
User Badges:

I have PIX 515E Firewall when I statrt it the following message appear in Hyper Terminal.

CISCO SYSTEMS PIX FIREWALL

Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73

Compiled by morlee

64 MB RAM


PCI Device Table.

Bus Dev Func VendID DevID Class Irq

00 00 00 8086 7192 Host Bridge

00 07 00 8086 7110 ISA Bridge

00 07 01 8086 7111 IDE Controller

00 07 02 8086 7112 Serial Bus 9

00 07 03 8086 7113 PCI Bridge

00 0D 00 8086 1209 Ethernet 11

00 0E 00 8086 1209 Ethernet 10

00 11 00 14E4 5823 Co-Processor 11


If anyone can guide me because my network is down for a few days

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
srue Wed, 08/01/2007 - 04:10
User Badges:
  • Blue, 1500 points or more

Is that were it stops? does it keep rebooting continuously? Or does it go into rommon mode?

vraghu Wed, 08/01/2007 - 04:17
User Badges:

Yest it stop even i can not go rommon mode by disturbing it by ESC or Break

vraghu Wed, 08/01/2007 - 20:27
User Badges:

Is there anyone to help me. The message which I posted the firewall stack after that. I cannot go to any mode. Please if anyone can help me.


Thank you in advance

JORGE RODRIGUEZ Thu, 08/02/2007 - 17:20
User Badges:
  • Green, 3000 points or more

as indicated by zubairjalal, you will have to rma it hoping you have a backup of the config , also it would be recomended to deploy a ASA failover solution, with this solution your network will not be down.

zubairjalal Thu, 08/02/2007 - 01:55
User Badges:
  • Bronze, 100 points or more

I think you should proceed with a RMA.


regards

Zubair

Actions

This Discussion