Router C has a SW LAN on network 192.168.1.0/24 while router B has 2 subnetworks 10.1.1.0/24 and 10.1.2.0/24 on either side. Now a new Router A is added to this network and has SW LAN on network 172.16.0.0/24. Router A is connected to the 10.1.1.0/24 subnet on Router B.
RtrB and RtrC are configured for RIPv1 and have complete connectivity. RtrA is added to the network. What is the most appropriate RtrA configuration for full connectivity?
Do I need to enable RIP and then add all these networks as follows:
or to enable RIP & add just Router A LAN and WAN networks
Thanks for your attention
If the device has an interface that belongs to that network and you want to announce it to other routers, then sure, include 192.168.1.0 under the RIP process.