->FXO->FXS-> call transfer not working...

Unanswered Question

We have cisco2811 with c2800nm-adventerprisek9-mz.124-16 and 1 FXO + 2 FXS ports.

at this moment i use CME B-ACD to auto answering and forward call to internal fxs port.

problem - this call, terminated to fxs, cann't be transferred by using flash button on analog phone(to transfer call from fxs to fxs port i use app-h450-transfer.

Can somebody tall me WHAT to use to make transfer feature working??

my config in attachment

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (2 ratings)
Paolo Bevilacqua Wed, 08/01/2007 - 07:24


do you have the documentation for app-h450-transfer ?

I think the service is meant to be configure on incoming dial-peer ?

Configuring Feature Mode for SCCP Analog Phones

This task configures feature mode for SCCP analog phones on the voice gateway and enables SCCP analog phones to invoke features using feature access codes after hook flash.


You must first configure full consultation transfer on Cisco CallManager using the transfer-system full-consult command in order for feature mode to work on the voice gateway.


1. enable

2. configure terminal

3. stcapp call-control mode feature

my IOS says that didn't know "stcapp" command....


This Discussion