Problems when configuring E1 controller

Unanswered Question
Aug 1st, 2007
User Badges:

I have a 3640 router. I also have a VWIC-MFT-E1 card and Im trying to setup a ppp connection to a branch office. I have configure the E1 controller and assigned an ip address of to serial interface "serial 0/2:0" but Im not able to ping the directly connected interface even though is up and up.

ideas ?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
royalblues Wed, 08/01/2007 - 12:14
User Badges:
  • Green, 3000 points or more

Can you post the router config on the other side?

BTW your output shows that the serial link is HDLC as opposed to PPP?

What interfaces are part of the multilink?



This Discussion