Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
643
Views
0
Helpful
4
Replies

3560G EMI or SMI

state
Level 1
Level 1

‎08-01-2007 01:57 PM - edited ‎03-05-2019 05:38 PM

Friends, when I do a show version, how can I determine if the 3560G switch is using EMI or SMI software?

Labels:
0 Helpful
4 Replies 4

sundar.palaniappan
Level 10
Level 10

‎08-01-2007 02:11 PM

Close to the bottom of the show version output you would see the Model Number and if it shows.

WS-C3560-24PS-E - EMI

WS-C3560-24PS-S - SMI

HTH

Sundar

0 Helpful

state
Level 1
Level 1
In response to sundar.palaniappan

‎08-02-2007 09:12 AM

Thank you

0 Helpful

andrew.butterworth
Level 7
Level 7

‎08-02-2007 01:58 AM

When you issue a 'show version' this 1st line of the output should say the software version and feature set (C3560-IPBASE or C3560-IPSERVICES). It is possible that switches shipped with IP Base (SMI) are running IP Services (EMI) or Advanced IP Services, however the hardware ID will remain the same. This is shown towards the end of the 'show version' output by the 'Model number:' - if it ends in a '-S' it was shipped with SMI if it ends in '-E' it was shipped with EMI.

There is a license fee payable for moving from SMI (IP Base) to EMI (IP Services) or Advanced IP Services.

HTH

Andy

0 Helpful

state
Level 1
Level 1
In response to andrew.butterworth

‎08-02-2007 09:12 AM

Thank you

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card