SFP Interconnect Cable

Unanswered Question
Aug 1st, 2007

The Catalyst 3560 product page shows an SFP interconnect cable that allows two switches to be connected directly using SFP ports.


Can these interconnect cable be used for other Catalyst switches (eg 4948) ?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
spremkumar Wed, 08/01/2007 - 19:21


The cables mentioned over here are very short in distance and if i were you i would go for other cable from a renowned vendor...

So that i an reuse the same if i have any requirement in later point of time...


aa@nvrlnd.com Thu, 08/02/2007 - 10:10

Thanks for reply.

So does that mean that SFP cables can be used to directly connect SFP ports on 2 different catalyst switches?

I'm trying to avoid having to buy SFP modules, which then sticks out of the port and is probably more expensive also.

Thanks again.


This Discussion