08-01-2007 10:43 PM - edited 03-14-2019 10:53 PM
Hi All,
I am using CCM 4.0 and my VG is 3745 router. Initially I had only one Voice Interface Card in my VG 3745 router for 23 channels/ports.
Now I installed one more Voice Interface Card in my VG 3745 router for more 23 channels/ports.
How can I change update my current CCM gateway setup to increase the Voice Interface Card selection?
08-02-2007 12:35 AM
i assume u have configured ur new gateway for the new T1 in the GW part, now in ur CCM admin page, u have to add this gateway, go to Device -> Gateway -> ur 3745 gateway -> besides subunit u will find like two ports -> configure the new gateway (the new t1 card) settings.
then under call routing - route hunt - route group add this new port (new t1) in ur existing route group
now calls will be circulated (default) between the two t1's
hth
/majdi
08-02-2007 02:51 AM
alternative (preferred if you are using H323 protocol in your VG), use Trunk group configuration:
1. at the global, enter: trunk group
2. under trunk group config, choose the scheme: hunt-scheme
3. optionally, you can limit the number of calls in this trunk group: max-call voice
4. once the you defined a trunk group, apply it into the dial-peer (say, going to PSTN): trunk-group
08-02-2007 02:55 AM
thanks for remark edison, yes i assumed MGCP GW.
Greetings
/majdi
08-02-2007 04:58 AM
08-02-2007 05:44 AM
no other config in ccm required (assuming the 2 T1s have the same expected digits when receiving/sending digits). it uses the existing h323 gateway device in ccm and all existing Route patterns pointing to your gateway.
hope this help.
Cheers!
08-02-2007 05:54 AM
from your configuration, the outgoing dial-peers should be okay. by adding preference command to your second dial-peer, VG will forward all calls to port 1/0. if all ports are busy, h323 gateway will automatically use the T1 in 2/0.
by using trunk group hunt scheme, you can manipulate the selection of the ports.
08-03-2007 04:22 AM
08-05-2007 10:36 PM
From my CCM report status, it is showing only 23 channels for my VG router, but actually my VG router has got 46 channels (46*2=92 channels total).
Why is it so? Is any config need to done in CCM?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide