SIP Inspection

Unanswered Question
Aug 1st, 2007
User Badges:

HI,


I have ASA 5510 withc csc module, i need to enable sip trafic (Udp 5060), the sip inspected by default, i opened the sip port from public to the Gatway ( private ip) in both direction but i cann't connect.


Note taht i use Static NAt for Gatway here under outr configuration


static (inside,outside) 82.10.229.100 10.10.100.8 netmask 255.255.255.255



service-policy global_policy

Class-map inspection_default

inspect sip


access-list outside permit udp any 82.10.229.100 eq sip

access-list outside permit tcp any host 82.10.229.100 eq sip



access-list inside permiy host 10.10.100.8 any



kindly advise


regards

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Anonymous (not verified) Wed, 08/08/2007 - 06:20
User Badges:

SIP is an ASCII-based, application-layer control protocol that can be used to establish, maintain, and terminate calls between two or more endpoints. Like other VoIP protocols, SIP is designed to address the functions of signaling and session management within a packet telephony network. Signaling allows call information to be carried across network boundaries. Session management provides the ability to control the attributes of an end-to-end call.

Actions

This Discussion