Policy Route Map

Unanswered Question


Anyone knows what is the policy route map below means..I am confused..

Thanks in advanced!


interface FastEthernet0/0.1

encapsulation dot1Q 1 native

ip address 122.1.x.x.255.255.0

no ip redirects

ip accounting access-violations

ip policy route-map ID


ip access-list extended ID

permit ip host any

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
mohammedmahmoud Thu, 08/02/2007 - 00:21
User Badges:
  • Green, 3000 points or more


Can you please post the route-map named "ID".


Mohammed Mahmoud.

cindylee27 Thu, 08/02/2007 - 00:39
User Badges:

Hi Mahmoud,

As below:

route-map ID permit 10

match ip address I/D

and sorry...ip access-list extended I/D should be the right one..


mohammedmahmoud Thu, 08/02/2007 - 00:49
User Badges:
  • Green, 3000 points or more

Hi Cindy,

Since the route-map doesn't has any set entry, thus it won't do anything, normal routing using the routing table shall be done.


Mohammed Mahmoud.

cindylee27 Thu, 08/02/2007 - 01:17
User Badges:

H Mahmoud,

How can we know there there is no set entry and also what is the number of 10 represents?

DO you have any example on this route-map ?

Thanks in advanced again!

Jon Marshall Thu, 08/02/2007 - 01:32
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi Cindy

If what you posted was the full output of the route-map then we know there is no set part to it. This basically means you can match as much as you like but nothing will be done.

You only have one entry but if you wanted another entry to your route-map you could another number eg.

route-map ID 20


The packet will be checked against each entry in your route-map until it finds a match.




This Discussion