08-02-2007 06:13 AM
I have run setup and given the ips an address that is consistent with the inside network. I reset but cannot ping the address either from an inside switch or from the asa. What am I doing wrong?
08-09-2007 11:40 AM
Make sure the subnet mask is also set right. This is where sometime we miss out. If everything is right reset and reconfigure the device once. Try adding a static ARP entry for the ip address of the device. In windiws command to enter a static ARP
arp -s
09-17-2007 07:53 AM
Hi,
I have the same situation. HOw did you reslove this issue?
09-20-2007 12:17 AM
The IP-address on the IPS-module is for management-purpose only, so you need to patch the ethernet interface on the outside of the module to you internal network. Also you need to make sure the IP-address is in the same subnet as the internal network!
Please rate if the post is usefull!
Regards,
Michael
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: