cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
368
Views
0
Helpful
2
Replies

CSS 11000 Problem with load balancing

ogieogilthorpe
Level 1
Level 1

I have inherited a used Cisco Css 11000 from a friend. I am trying to set up a test environment to get a jump on my classes this upcoming semester. So far I have had no problems setting it up to load balance connections between four "servers".

But i started to notice something rather strange with it the other day. One server is getting alot more connections then the other three when i test. Here are the stats

Service State Conn Weight Avg load

test1 Alive 22 1 2

test2 Alive 52 1 2

test3 Alive 15 1 2

test4 Alive 142 1 39

So when i take test4 out of that content group the other three servers load balance fine. It is just when that one is in there does it do this.

Does anyone have any ideas on what it might be? Because I am totally lost.

2 Replies 2

Gilles Dufour
Cisco Employee
Cisco Employee

what kind of loadbalancing method do you use ?

Can we see the content rule ?

Thanks,

Gilles.

here is the conf

CSS11050# sh run

!Generated on 07/31/2007 10:10:48

!Active version: ap0500605

configure

!*************************** GLOBAL ***************************

restrict ftp

username test des-password xxxxxxxx superuser

arp timeout 60

arp wait 15

no restrict web-mgmt

no restrict xml

snmp name "test-load1"

snmp contact "555-1212"

snmp location "here"

snmp community test01 read-only

app

ip route 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx 3

!************************* INTERFACE *************************

interface e1

description "UPLINK"

interface e2

description "TO-SWITCH"

interface e8

description "FAILOVER"

!************************** CIRCUIT **************************

circuit VLAN1

description "MAIN_VLAN"

ip address xxx.xxx.xxx.xxx 255.255.255.0

ip virtual-router 1 preempt

ip redundant-interface 1 xxx.xxx.xxx.xxx

!************************** SERVICE **************************

service test1

ip address xxx.xxx.xxx.xxx

active

service test2

ip address xxx.xxx.xxx.xxx

active

service test3

ip address xxx.xxx.xxx.xxx

active

service test4

ip address xxx.xxx.xxx.xxx

active

!*************************** OWNER ***************************

owner test

content test1

vip address xxx.xxx.xxx.xxx

protocol tcp

port 80

sticky-inact-timeout 30

add service test1

add service test2

add service test3

add service test4

advanced-balance sticky-srcip

active

CSS11050#

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: