How to direct data traffic to particular interfaces

Answered Question
Aug 2nd, 2007

My company is has a two router system, where one router uses frame-relay to our WAN, for remote offices and connects to the HQ LAN. The other router which uses frame-relay to connect to our ISP, for Internet, then connects to the LAN. We are going to a single ATM DS3. The Cisco 3825 router will have a single ATM connection and two gigethernet connections. I will have to configure 10 subinterfaces on the ATM interface. How can I configure the router to have traffic in and out of ATM subs 1&2 go to gigeth0. Then have traffic in and out of ATM subs 3-10 go to gigeth1?

I have this problem too.
0 votes
Correct Answer by mohammedmahmoud about 9 years 2 months ago


Have a look at PBR:

PBR (Policy Based Routing).

Policy-Based Routing

Configuring Policy-Based Routing


Mohammed Mahmoud.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)


This Discussion