AP HWIC Will Not Transmit

Unanswered Question
Aug 2nd, 2007

Hey There Folks,

I have a 3845 router with an AP HWIC installed. The module doesn't seem to transmit any signal. I'm not picking up a thing. Below is what I have configured. I made it real basic; nothing fancy like my 1200 series AP's have on them. I figured these modules would be a cinch to get working, but I'm not having any luck. Plus, the second dot11radio interface is showing reset and down if I do a "sh ip int br"; not for sure why that's happening either. Maybe my module is faulty or something? This implementation should have been pretty simple.

bridge irb

!

dot11 ssid (ssid removed for sec reasons)

authentication open

guest-mode

!

!

interface Dot11Radio0/2/0

no ip address

!

encryption mode ciphers tkip wep128

!

ssid (removed for sec reasons)

!

speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0

station-role root access-point

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

!

!

interface Dot11Radio0/2/1

no ip address

!

encryption mode ciphers tkip wep128

!

ssid (removed for sec reasons)

!

speed basic-6.0 9.0 basic-12.0 18.0 basic-24.0 36.0 48.0 54.0

station-role root access-point

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

!

!

interface BVI1

ip address 192.168.240.1 255.255.255.0

ip access-group 100 in

!

!

bridge 1 protocol ieee

Any info as to what I'm doing wrong would be great!

Thanks,

Erik

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode