NAT Setup

Unanswered Question
Aug 3rd, 2007

I need some help with setting up NAT on my cisco router. I know how to add port forwarding, eg. ip nat inside source etc... . My question is how do I remove this line or how do I change this line.

Thanks

Jeremy

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
mohammedmahmoud Fri, 08/03/2007 - 13:23

hi Jeremy,

You need to clear the NAT translation table first, kindly use "clear ip nat translation *" command.

HTH,

Mohammed Mahmoud.

jheatherington Fri, 08/03/2007 - 13:52

Does this clear all entries in the nat translation table, and then you have to re-enter them all. Just making sure so that I don't forget to readd some.

Thanks

Jeremy

Actions

This Discussion