Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
273
Views
0
Helpful
1
Replies

Routing problem

tmcmillion
Level 1
Level 1

‎08-03-2007 01:47 PM - edited ‎03-05-2019 05:42 PM

I have the following topology: coresw>distributionsw>accesssw1>PtP WAP Bridge>accesssw2>router

VLAN300 is setup on the coresw and popultaes across to accesssw2 and i am able to ping DGW vlan 300 from every device on the network accept the router, this router is on vlan 300 and is connected to accesssw2 on a vlan300 port, i have the DGW for vlan300 defined on the router as well.

I know this is something with topolgy but can't figure it out.

Labels:
0 Helpful
1 Reply 1

Jon Marshall
Hall of Fame
Hall of Fame

‎08-09-2007 10:21 AM

Hi

Are there any other interfaces on the router. Have you tried using the extended ping on the router with the source interface address being the one that is in vlan 300 ?

Jon

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card